- To get into the starting position, hold your body at arm’s length with your arms nearly locked above the bars.
- Now, inhale and slowly lower yourself downward. Your torso should remain upright and your elbows should stay close to your body. This helps to better focus on triceps involvement. Lower yourself until there is a 90 degree angle formed between the upper arm and forearm.
- Then, exhale and push your torso back up using your triceps to bring your body back to the starting position.
- Repeat the movement for the prescribed amount of repetitions.
Variations: If you are new at this exercise and do not have the strength to perform it, use a dip assist machine if available. These machines use weight to help you push your body weight.
Otherwise, a spotter holding your legs can help.
More advanced lifters can add weight to the exercise by using a weight belt that allows the addition of weighted plates.
The purpose of the board press is to train specific ranges of the pressing motion in order to increase overall power for a bigger bench press. This is actually pretty simple. The lifter places a stack of boards on his chest.
The bar is lowered until it touches the boards, and is pressed back up. The great thing about board presses is that both the positive and negative ranges of motion can be restricted and it is dependent upon the lifters preference. This can be done by simply choosing the height of the boards or how many boards to use.
With a complete set of boards the lifter can choose which part of his range of motion to concentrate on or restrict. For example one 4 inch board works the range of motion from 4 inches off the chest up to lockout.
Each additional board height decreases the range of motion. The more boards that are used the more the triceps are involved in the movement. The top half of the bench press really targets the triceps which is why you want to limit the range of motion when training simply to get bigger arms.
- Start by setting a bar attachment (straight or e-z) on a high pulley machine.
- Facing the bar attachment, grab it with the palms facing up (supinated grip) at shoulder width. Lower the bar by using your lats until your arms are fully extended by your sides. Tip: Elbows should be in by your sides and your feet should be shoulder width apart from each other. This is the starting position.
- Slowly elevate the bar attachment up as you inhale so it is aligned with your chest. Only the forearms should move and the elbows/upper arms should be stationary by your side at all times.
- Then begin to lower the cable bar back down to the original staring position while exhaling and contracting the triceps hard.
- Repeat for the recommended amount of repetitions.
- Lie back on a flat bench. Using a close grip (around shoulder width), lift the bar from the rack and hold it straight over you with your arms locked. This will be your starting position.
- As you breathe in, come down slowly until you feel the bar on your middle chest. Tip: Make sure that – as opposed to a regular bench press – you keep the elbows close to the torso at all times in order to maximize triceps involvement.
- After a second pause, bring the bar back to the starting position as you breathe out and push the bar using your triceps muscles. Lock your arms in the contracted position, hold for a second and then start coming down slowly again. Tip: It should take at least twice as long to go down than to come up.
- Repeat the movement for the prescribed amount of repetitions.
- When you are done, place the bar back in the rack.